Форум OlegON > Компьютеры и Программное обеспечение > Железо

Черный экран с момента включения до логона в Windows : Железо

28.03.2024 18:55


09.04.2019 11:30
baggio
 
Модель системника фото разъемов предоставьте ..
09.04.2019 11:58
OlegON
 
HP 400G5Em



COM отсутствует
09.04.2019 14:16
baggio
 
На этих системниках по display port не идет изображение до загрузки..
Используй dsub...
Причина скорее всего в том что dp это не только видео...
09.04.2019 14:18
OlegON
 
так я о чем и толкую в первом сообщении, на него тоже не идёт сигнал...
09.04.2019 18:11
baggio
 
у тебя в какой из трех разъемов монитор воткнут?
в нижний\верхний\средний?

просто у тебя там судя по всему...
Цитата:
GRAPHICS
Integrated Intel® UHD Graphics 630; Intel® UHD Graphics 610 [36] Discrete AMD Radeon™ R7 430 Graphics (2 GB GDDR5 dedicated); AMD Radeon™ RX 550 Graphics (4 GB GDDR5 dedicated)

и она по ходу нижняя... нижний DP...
и если она в биосе стоит как primary то на верхних двух нигуя не будет пока винда не загрузится...
09.04.2019 18:26
baggio
 
When a graphics card is installed in one of the system board slots, the video connectors on the graphics card and the integrated graphics
on the system board may be used at the same time. However, for such a conƭguration, only the display connected to the discrete graphics
card will display POST messages.
The system board graphics can be disabled by changing settings in Computer Setup.

09.04.2019 18:27
baggio
 
 Integrated
Video
Setting When checked, enables the integrated video device.
When not using the integrated video, disable the
integrated video to save system memory.
Checked Desktop with
add-in graphics
card only

09.04.2019 18:29
baggio
 
If the system has multiple video sources (embedded, PCI, or PCI-Express adapters) installed (embedded
video on some models only) and a single monitor, the monitor must be plugged into the monitor connector
on the source selected as the primary VGA adapter. During boot, the other monitor connectors are disabled
and if the monitor is connected into these ports, the monitor will not function. You can select which source
will be the default VGA source in Computer Setup.
09.04.2019 19:50
OlegON
 
Как я понял из приведенного, сначала там была еще одна карта, сделали

Цитата:
baggio disable the
integrated video to save system memory
после чего карту выдернули и вообще ни одна не работает...
Когда комп, судя по всему, пошел диски проверять, я в какой только порт не совал DP, а VGA тоже подключен.
10.04.2019 09:46
baggio
 
нужно лезть в биос и смотреть... что атм выставлено....
Часовой пояс GMT +3, время: 18:55.

Форум на базе vBulletin®
Copyright © Jelsoft Enterprises Ltd.
В случае заимствования информации гипертекстовая индексируемая ссылка на Форум обязательна.